The microcontroller on the Arduino AVR based board has EEPROM: memory whose values are kept when the board is turned off (like a tiny hard drive). This library enables you to read and write those bytes.

The supported micro-controllers on the various Arduino boards have different amounts of EEPROM: 1024 bytes on the ATmega328, 512 bytes on the ATmega168 and ATmega8, 4 KB (4096 bytes) on the ATmega1280 and ATmega2560.

Examples

• EEPROM Clear: Clear the bytes in the EEPROM.
• EEPROM Read: Read the EEPROM and send its values to the computer.
• EEPROM Write: Stores values from an analog input to the EEPROM.
• EEPROM Crc: Calculates the CRC of EEPROM contents as if it was an array.
• EEPROM Get: Get values from EEPROM and prints as float on serial.
• EEPROM Iteration: Understand how to go through the EEPROM memory locations.
• EEPROM Put: Put values in EEPROM using variable semantics.
• EEPROM Update: Stores values read from A0 into EEPROM, writing the value only if different, to increase EEPROM life.

Functions

• read()
• write()
• update()
• get()
• put()
• EEPROM[]