Reference   Language | Libraries | Comparison | Changes

Stepper: step(steps)

Description

Turns the motor a specific number of steps, at a speed determined by the most recent call to setSpeed(). This function is blocking; that is, it will wait until the motor has finished moving to pass control to the next line in your sketch. For example, if you set the speed to, say, 1 RPM and called step(100) on a 100-step motor, this function would take a full minute to run. For better control, keep the speed high and only go a few steps with each call to step().

Parameters

steps: the number of steps to turn the motor - positive to turn one direction, negative to turn the other (int)

Returns

None

See also

• Stepper(steps, pin1, pin2)
• Stepper(steps, pin1, pin2, pin3, pin4)
• setSpeed(rpm)

Reference Home

Corrections, suggestions, and new documentation should be posted to the Forum.

The text of the Arduino reference is licensed under a Creative Commons Attribution-ShareAlike 3.0 License. Code samples in the reference are released into the public domain.